Guralp-systems CMG-6TD Manual do Utilizador descarregar pdf (Página 10)

CMG-6TD Introduction

At this location, which can be up to 500 metres away, a low-power CMG-EAM

data module might act as an access point for the array elements and forward

data onto a higher-bandwidth radio link.

In semi-permanent arrays, a wireless-enabled EAM or laptop PC can be set up

as a temporary access point for the duration of a site visit.

MAN-T60-0002 10 Issue F - February 2014

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 107 108

Operator's guide 1
Table of Contents 2
1 Preliminary Notes 6
2 Introduction 7
2.2 Options 8
3 First encounters 11
3.2 Test installation 12
4 Installing the 6TD 18
4.2.2 The Break-out box 19
4.3 Installation notes 20
4.4 Installing in vaults 21
4.5 Installing in pits 23
4.7 Rapid installation 27
4.8 Recovery 30
4.9 Networking overview 31
4.10.1 Using DeviceInstaller 33
4.10.2 Using DHCP 35
4.11.1 Using DeviceInstaller 37
4.11.2 Using DHCP 39
4.13.1 Reading 6TD disks 44
5 Configuration with Scream! 49
5.1.1 System ID 50
5.1.2 Output control 51
5.1.3 Triggering 52
5.1.3.1 STA/LTA triggering 53
5.1.3.2 Level triggering 57
5.1.4 Mux Channels 58
5.1.5 Ports 59
5.2.1 System 61
5.2.2 Triggering 62
5.2.3 Calibration 62
5.2.4 Data flow 63
5.2.4.1 Heartbeat messages 64
5.2.5.1 DIRECT 65
5.2.5.2 FILING 66
5.2.5.3 DUPLICATE 66
5.2.5.5 ADAPTIVE 68
5.2.5.6 DUAL 68
5.3 digitiser status streams 69
5.3.1 GPS 70
6 Calibrating the 6TD 72
6.5 Calibration methods 75
6.5.2 Sensor response codes 78
6.6 The coil constant 79
7 Command-line interface 80
7.2 General configuration 81
7.2.2 BAUD 82
7.2.3 LOAD 82
7.2.4 LOAD-I 82
7.3 GPS and timing systems 83
7.3.2 HR-CYCLE 84
7.3.3 XGPS 84
7.3.4 SET-RTC 84
7.3.5 SET-CLOCK 84
7.3.6 TIME? 85
7.3.7 .FIX 85
7.3.8 .POSITION 85
7.4 Output configuration 86
7.4.2 SET-TAPS 87
7.5 Triggering 88
7.5.2 TRIGGERED 89
7.5.3 STA 89
7.5.4 LTA 89
7.5.5 RATIOS 90
7.5.6 BANDPASS 90
7.5.7 PRE-TRIG 90
7.6 Calibration 91
7.6.2 SQUAREWAVE 92
7.6.3 RANDOMCAL 92
7.7 Actions 93
7.8 Flash storage and filing 94
7.8.3 FROM-TIME 95
7.8.4 TO-TIME 95
7.8.5 ALL-TIMES 96
7.8.6 ALL-FLASH 96
7.8.7 ALL-DATA 96
7.8.8 STREAM 96
7.8.9 STATUS-ONLY 97
7.8.10 S/S 97
7.8.11 FLUSH 97
7.8.12 FLUSHALL 97
7.8.13 RESET-FLASH 97
7.8.14 ERASEFILE 98
8 Updating the 6TD 99
9 Connector pin-outs 101
9.2 Breakout box connectors 104
9.2.2 Breakout box GPS port 105
9.2.3 Breakout box power port 106
10 Specifications 107
11 Revision history 108

Comentários a estes Manuais

Sem comentários

Guralp-systems CMG-6TD Manual do Utilizador Página 10

Comentários a estes Manuais